CHPCX - LA PREM MP/GLOSS T BSE, FZ 1220
- MSDS: CHPCX
- Manufacturer: LASTING PAINTS INC
- Product Name: LA PREM MP/GLOSS T BSE, FZ 1220
- National Stock Number: 8010-00N088461
Product Identification
Product ID:LA PREM MP/GLOSS T BSE, FZ 1220
MSDS Date:10/22/1997
FSC:8010
NIIN:00N088461
MSDS Number: CHPCX
Responsible Party
BALTIMORE, MD 21223
US
Emergency Phone: 410-947-6306
Info Phone: 410-947-6300
Cage: 35178
Contractor
Cage: 35178
Ingredients
10.
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 26.7%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:VAPOR HARMFUL. MAY AFFECT BRAIN OR
NERVOUS SYSTEM CAUSING DIZZINESS, HEADACHE OR NAUSEA. CAN CAUSE
EYE, SKIN, NOSE AND THROAT IRRITATION. SWALLOWING CAUSES
GASTROINTESTINAL IRRITATION. LIQUID ABSORBED BY LUNG CAN CAUSE
INJURIES ELSEWHERE. NOTICE:REPORTS HAVE ASSOCIATED REPEATED &
PROLONGED OCCUPATIONAL(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:OVEREXPOSURE TO SOLVENTS W/PERMANENT
BRAIN & NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING & INHALING CONTENTS MAY BE HARMFUL OR FATAL.
Medical Cond Aggravated by Exposure:EXCESSIVE INHALATION BY PERSONS
W/PRE-EXISTING RESPIRATORY CONDITIONS COULD HAVE THE PROBLEM
ADDITIONALLY AGGRAVATED.
First Aid
First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATHING. TREAT
SYMPTOMATICALLY. CONSULT MD. EYES:FLUSH IMMEDIATELY W/LARGE AMOUNT
OF WATER FOR AT LEAST 15 MINUTES. CONSULT MD. SKIN:WASH AFFECTED
AREAS W/SOAP & W ATER. REMOVE CONTAMINATED CLOTHING. CONSULT MD IF
IRRITATION PERSISTS. INGEST:DRINK 1-2 GLASSES OF WATER TO DILUTE.
DO NOT INDUCE VOMITING. CONSULT MD OR POIS CTL CTR IMMED. TREAT
SYMPTOMATICALLY.
Fire Fighting
Flash Point:108F,42C
Lower Limits:SEE ING 1
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL, WATER FOG. USE ANY CLASS
B APPROVED FIRE EXTINGUISHER.
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP .
WATER SPRAY MAY BE INEFT. IF WATER IS USED, FOG NOZZ ARE PREF.
WATER MAY BE USED TO COOL CNTNRS TO PVNT (SUPDAT)
Unusual Fire/Explosion Hazard:COMBUST LIQ-CLASS II. KEEP CNTNR TIGHTLY
CLSD. ISOLATE FROM HEAT, ELEC EQUIP, SPKS & OPEN FLAME. CLSD CNTNRS
MAY EXPLODE WHEN EXPOS TO EXTREME HEAT. (SUPP DATA)
Accidental Release
Spill Release Procedures:REMOVE SOURCES OF IGNITION & PROVIDE
VENTILATION. USE SCOOP ON LARGE SPILLS & ABSORBENT MATERIAL ON
SMALL SPILLS. AVOID BREATHING VAPOR & USE NIOSH APPROVED
RESPIRATORY PROTECTION. FLUSH AREA W/WATER. HOLD CLEAN-UP
MATERIALS FOR PROPER DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE AWAY FROM HEAT, SPARKS & OPEN
FLAME IN WELL VENTILATED AREA. DO NOT STORE >100F. KEEP CLOSURE
TIGHT & CONTAINER UPRIGHT TO PREVENT LEAKAGE.
Other Precautions:DO NOT PUNCTURE, DRAG OR SLIDE CNTNRS. DO NOT GET IN
EYES. AVOID SKIN CONT. PREVENT PRLNG/RPTD BRTHG OF VAP/SPRAY MIST.
DRUMS SHOULD BE GROUNDED WHEN POURING. RESTRICT FREE FALL OF LIQ TO
A FEW INCHES TO AVOID GENERATION OF STATIC CHARGE.
Exposure Controls
Respiratory Protection:UNRESTRICTED VENTILATION:NIOSH APPROVED
MECHANICAL FILTER TO REMOVE SOLID PARTICLES. RESTRICTED
VENTILATION:USE NIOSH APPROVED CHEMICAL/MECHANICAL FILTER TO REMOVE
BOTH VAPOR & SOLIDS. NO VENTILATION: USE NIOSH APPROVED AIR LINE
TYPE RESP.
Ventilation:VENT SYS SHOULD BE DESIGNED & MAINTAINED TO PROVIDE VOL &
PATTERN TO PVNT CONC IN EXCESS OF TLV. WHEN THIS PROD (SUPDAT)
Protective Gloves:NEOPRENE/OTHER IMPERVIOUS TYPE GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING WASHROOM.
SMOKE IN DESIGNATED AREAS ONLY.
Supplemental Safety and Health
FIRE FIGHT PROC:PRESSURE BUILD-UP & EXPLOSION. EXPLO HAZ:APPLICATION TO
HOT SURFACES REQUIRES SPECIAL PRECAUTIONS. VENT:IS BURNED OR WELDED
THROUGH, VENTILATION SHOULD BE PROVIDED.
Chemical Properties
Boiling Pt:B.P. Text:>311F,>155C
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Spec Gravity:1.2
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:43.54
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT & OPEN FLAME.
Hazardous Decomposition Products:CARBON MONOXIDE & OTHER ORGANIC
MATERIALS MAY BE FORMED DURING COMBUSTION.
Disposal
Waste Disposal Methods:DISPOSAL SHOULD BE DONE I/A/W FEDERAL, STATE &
LOCAL REGULATIONS. BEFORE ATTEMPTING CLEAN-UP, REFER TO HAZARD
CAUTION INFORMATION IN OTHER SECTIONS OF THIS MSDS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.